driving up a steep slope for a long period of time), the i-200 engine
will power off and stop after 15 seconds.
WARNING
When the i-200 turns off during a Safety
Alert, all operation systems will halt. Do
not continue attempting to ride the
i-200 when the system initiates a stop.
Turn your i-200 off and back on to
unlock it from a Safety Lock.
CHARGING YOUR i-200
CHARGING THE i-200
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet. The charging
indicator light ON THECHARGER will be green.
• Connect the cable with the power supply (l OOV 240V; 50/60 Hz).
• Align and connect the 3-pin charging cable into the charging
port of the i-200. DO NOT FORCE THE CHARGER INTO THE CHARGE
PORT, AS THIS MAY CAUSE THE PRONGS TO BREAK OFF OR
PERMANENT DAMAGE TO THE CHARGE PORI
• Once attached to the board, the charging indicator light ON THE
CHARGER should change to RED, indicating that your device is now
being charged.
• When the RED indicator light on your charger turns to GREEN, then
your i-200 is fully charged.
• A full charge may take up to 6 hours. While charging, you will see
a yellow flashing light on the scooter, which also indicates charging.
Do not charge for more than 7.5 hours.
•After fully charging your i-200, Unplog the charger from your i-200
and from the power outlet.
18
To Next Page
Loading...
