10
2. Secure the Raptor to your hoverboard using 2 of the included hook and loop straps. The other 2 straps
included are spares. With the fastener side facing away from your hoverboard, thread the straps through the
front hole of each handlebar mount.
3. Wrap both straps under your hoverboard and pull them through to the other side. Insert the straps into the
rear hole of the handlebar mounts. Fasten the front and rear sides of the straps. The rubber protectors on the
straps should be centered underneath the hoverboard, with side B (as shown in the diagram below) facing
the ground. Make sure they are tightly secured to the hoverboard.
To Next Page
Loading...
