HP 1080p - Powering and Assembling the TV; Connecting Power to the TV; Stand Removal and Attachment

Setting Up the TV
Setting Up the TV 21
Connecting power to the TV
1 Connect the AC power cord to the connector on
the rear of the TV.
2 Connect the AC power cord into the AC power
outlet.
3 Insert the cable clamp from the box into the
square hole on the rear of the TV.
4 Route the cables through the cable clamp.
Removing or attaching the
stand
Your TV comes with the stand attached. Reverse these
steps to attach the stand.
Before removing the stand, unplug the AC power cord
from the AC power outlet, and remove any cabling.
1 Carefully place the TV panel with the glass screen
facing downward on a padded, stable table with
the TV stand extended over the edge of the table.
2 Remove four long screws that secure the stand
(pedestal) to the rear of the TV, and then lift off the
stand.
c
CAUTION: Use two people to disassemble
or assemble the TV.
w
WARNING: Do not allow the stand to drop
onto the TV panel.