b. Enter the number of digits for the barcode number in the Digit Length box. For example,
if you enter “3” the barcode numbers will be 001, 002, 003, etc.
c. Enter the barcode suffix (one or two alphanumeric characters) in the Barcode Suffix box.
No special characters are permitted.
d. Enter the starting barcode number in the Starting # box.
e. Click Add to add the new barcode template.
f. To add another barcode template, repeat these steps.
4. Click the radio button next to the barcode template you want to use to create the cartridges.
NOTE: NetBackup has total barcode limit of eight characters. HP Data Protector has a total
barcode limit of 16 characters. Check your user guide for other backup applications.
5. Click Next Step.
6. Select the type of physical cartridge to emulate (Figure 22 (page 100)).
7. Click Next Step.
Figure 22 Create Virtual Library Wizard window (9 of 12)
8. Enter the number of cartridges and the cartridge size in the appropriate boxes (Figure 23 (page
101)).
The default number of cartridges is based on the maximum number of slots configured for the
virtual library. The default cartridge size is based on the actual size of the type of cartridge
emulated.
If there are multiple storage pools on your system, you must select the pool in which to create
cartridges from the —> Available capacity list.
The system calculates and displays the amount of required storage. If the required storage
exceeds what is available, the overage appears in red. You can allow the oversubscription
of storage capacity (see “Enabling and Disabling Oversubscription” (page 88)), or you can
change either the number of cartridges or the cartridge size (or both) to correct the overage
condition.
100 Configuration
To Next Page
Loading...
