Front Panel LEDs and Buttons
StatusDescriptionItem
Blue = Identification is activated.UID button/LED1
Flashing blue = System is being remotely managed.
Off = Identification is deactivated.
Green = System health is normal.Health LED2
Amber = System health is degraded. To identify the
component in a degraded state, see HP Systems
Insight Display LEDs and Internal Health LED
Combinations.
Red = System health is critical. To identify the
component in a critical state, see HP Systems Insight
Display LEDs and Internal Health LED Combinations.
Off = System health is normal (when in standby
mode).
Green = System is on.Power On/Standby button and system power LED3
Amber = System is in standby, but power is still
applied.
Off = Power cord is not attached, power supply
failure has occurred, no power supplies are installed,
facility power is not available, or the power button
cable is disconnected.
Rear Panel Components
DescriptionItem
Slot 1 PCIe2 x8 (8, 4, 2, 1)
1
1
Slot 2 PCIe2 x16 (16, 8, 4, 2, 1), 75W +EXT 75W
1, 2
2
Power supply 13
VLS Node Components, LEDs, and Buttons 147
To Next Page
Loading...
