Power Supply
CAUTION: To prevent improper cooling and thermal damage, do not operate the node unless
all bays are populated with either a component or a blank.
1. Disconnect the power cord from the power supply.
2. Press the power supply release lever (1), and then pull the power supply from the node.
To replace the component:
WARNING! To reduce the risk of electric shock or damage to the equipment, do not connect
the power cord to the power supply until the power supply is installed.
1. Remove the protective cover from the connector pins on the power supply.
2. Slide the power supply into the bay until it clicks.
3. Use the strain relief clip to secure the power cord.
4. Connect the power cord to the power supply.
VLS Node Component Replacement 159
To Next Page
Loading...
