HP 12000 - DVD-CD Drive

NOTE: The replacement drive is automatically configured to RAID 1; no administrator action is
required.
DVD-CD Drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the node unless
all bays are populated with either a component or a blank.
1. Power off the node.
NOTE: The ejector button for the CD-ROM drive is recessed to prevent accidental ejection;
it may be helpful to use a small, flat, blunt object, such as a key or pen, to push the ejector
button.
2. Press the ejector button in firmly until the DVD-CD drive ejects (1).
3. Pull the DVD-CD drive out of the node (2).
To replace the component:
1. Carefully align the connector on the rear of the drive with the connector on the DVD-CD drive
interface board.
2. Slide the drive into the bay until it clicks.
158 Component Replacement