5. To remove fan module 2 or 3:
a. Remove the power supply air baffle.
b. Remove fan module 2 or 3.
To replace the component, reverse the removal procedure.
IMPORTANT: After installing the fan module, firmly press the top of the module connectors to
ensure the connectors are seated properly.
FBDIMM
1. Power off the node.
2. Extend or remove the node from the rack. See Extending a VLS Node from the Rack or
Removing a VLS Node from the Rack.
3. Remove the access panel.
4. Open the FBDIMM slot latches.
5. Remove the FBDIMM.
CAUTION: Use only Compaq branded or HP FBDIMMs. FBDIMMs from other sources may
adversely affect data integrity.
To replace the component, reverse the removal procedure.
VLS Node Component Replacement 161
To Next Page
Loading...
