Table 17 CLI Configuration Commands (continued)
Usage
1
Command
-h - Displays command usage information (optional)
Enables or disables oversubscription and specifies the percent storage remaining for
notification. Where the options are:
-e <n> - Enable/disable oversubscription (0-Disabled or 1-Enabled) (required)
setOverSubscription
-p <n> - Percentage of capacity remaining for alert notification (required)
-h - Displays command usage information (optional)
Returns whether the oversubscription feature is enabled or disabled and the capacity
remaining percentage for notification alert. Oversubscription is enabled when enabled
= 0. Oversubscription is disabled when enabled = 1.
getOverSubscription
Returns a list of available library emulation types. Displays each library emulation's name,
type, product, revision, and vendor information. Where the options are:
-l - List only licensed types (optional)
getLibTypes
-h - Displays command usage information (optional)
Creates a new library with the specified maximum number of cartridge slots, input/export
ports, and tape drives. Where the options are:
-a <n> - Node ID of the node on which the library emulation will reside (0, ...) (required)
createLibrary
-l <n> - LUN number to assign to library (-1 to 128) (optional)
-n <n> - Maximum number of tape drives (required)
-p <s> - Product (spaces allowed) (MSL6000, ...) (required)
-pm <n> - FC port to which this library is mapped (0, 1, ...) (required)
-pt <n> - Maximum number of input/export ports (required)
-r <s> - Revision (0430, ...) (required)
-sl <n> - Maximum number of cartridge slots (required)
-t <s> - Library type name (required)
-v <s> - Vendor (HP, ...) (required)
-y <n> - Library type to emulate (2051, ...) (required)
-h - Displays command usage information (optional)
Returns a list of the libraries defined on the VLS.getLibs
Returns a summary of the specified library. Where the options are:
-a <s> - Name of library (Library_0, ....) (required)
getLib
-h - Displays command usage information (optional)
Returns a summary of the slot status for each defined library (open:used:total).getLibOpenSlots
Deletes the specified library from the VLS. This operation takes several minutes to perform.
Where the options are:
-a <n> - Node number on which the library emulation resides (0, ...) (optional)
destroyLib
-f - Force. This parameter is ignored and is present only for backward compatibility
(optional)
-l <n> - LUN number of the library to delete (required)
-h - Displays command usage information (optional)
Returns a list of all tape drive emulation types available. Displays each tape drive
emulation's name, type, product, revision, and vendor information. Where the options
are:
-l - List only licensed types (optional)
getTapeTypes
-h - Displays command usage information (optional)
138 CLI Command Set
To Next Page
Loading...
