HP 212A - Specifications

SPECIFICATIONS
PULSE LENGTH: At least 0.07 to 10 microaeconda, continuously variable.
PULSE AMPLITUDE:
At least 50 volts peak into 50 ohm load (50 watts peak J.
PULSE POLARITY: Positive or Negative.
AMPWTUDE CONTROL:
(a)
50 db attenuator, variable in 10 db steps.
(b)
Cantinuoualy variable control with range of at least 10 db.
PULSE SHAPE: (a) Rise and decay time approximately 0.02 microseconds
(10% to 90yoo),
(b)
Crest variation less than f 5% of average peak amplitude.
JITTER: Less than 0.01 microseconds.
INTERNAL IMPEDANCE:
50 ohms or less on either pulse polarity.
REPETITION RATE: (a) Internal ~ynchronization, 50 to 5, 000 pps.
(b)
External 8 ynchronization,%Z to 5, 000 pps.
SYNC IN: Positive or negative, 5 volts peak minimum.
SYNC OUT:
(a)
25 volt5 poaitive or 15 voIte negative into 2, 000 ohm load.
(b)
Duration, approximately 1 microsecond at half voltage points.
(c) Rise time, approximately 0.25 microseconds.
PULSE POSITION:
(a)
Delay, 0 to 100 microseconds after Bync out pulse with
repetition
rate up to 2500 pps.
(b)
Delay. 0 to 50 micraseconds after sync out pulse with
repetition rate up to 5000 pps.
(c)
Advance, 0 to 10 microseconds after sync out pulse with
repetition rate up to 5000 pps.
CONNECTORS: (a) Main pulse, Type N.
(b) Sync in, sync out, Type BNC.
POWER SUPPLY: 1151230 volts flO70, 50fb0 cps, 380 watts maximum.
DIMENSIONS: Cabinet Mount: 20-314" wide, 12-314'' high, 14-31 16" deep.
Rack Mount: 19" wide, 10-112" high, 14-314" deep.
WEIGHT: Cabinet Mount: 58 lbs. , shipping weight approximately 76 lbs.
Rack Mount; 50 lbs, , shipping weight approximately 73 lba.
ACCESSORIES AVAILABLE:
@I AC-16F Cable Assembly, qype N Male to Type N Male
Fittings.
AC-E6K Cable xsaembly, BNC to BNC.
#17 End Frames, with handles for bench use, (for 21ZAR
Rack Mount).
I
I