2. Remove the rubber feet (see Computer feet on page 32).
Remove the bottom cover:
1. Remove the four Phillips M2.5 × 6.0 screws (1) in the feet area, and the two Phillips M2.5 × 4.0 screws (2)
in the front part of the bottom cover.
2. Use a thin plastic tool (1) to release the back cover. Work your way around prying to disengage the
bottom cover from the computer, and then remove the cover (2).
Reverse this procedure to install the bottom cover.
34 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
