HP 2510p - Compaq Business Notebook Maintenance And Service Guide

8. If it is necessary to replace the display bezel or display hinges, remove the following:
(1) Four rubber screw covers on the display bezel top edge
(2) Two rubber screw covers on the display bezel bottom edge
(3) Four Phillips PM2.5×7.0 screws on the display bezel top edge
(4) Two Phillips PM2.5×7.0 screws on the display bezel bottom edge
NOTE: See Display inverter on page 48 for display inverter replacement instructions.
9. Flex the inside edges of the left and right sides (1) and the top and bottom sides (2) of the display
bezel until the bezel disengages from the display enclosure.
10. Remove the display bezel (3). The display bezel is available using spare part numbers 501111-001
(for use with computer models equipped with WLAN and WWAN capability) and 501112-001 (for
use with computer models equipped with WLAN and WWAN capability and with webcam).
11. If it is necessary to replace the display hinges, remove the four Phillips PM2.5×5.0 screws (1) that
secure each display hinge to the display panel.
72 Chapter 4 Removal and replacement procedures

HP 2510p - Compaq Business Notebook Specifications

General

Display	12.1-inch WXGA (1280 x 800)
Graphics	Intel GMA X3100
Processor	Intel Core 2 Duo U7600
RAM	Up to 4 GB DDR2 SDRAM, 667 MHz
Storage	80/120 GB 5400 RPM
Operating System	Windows Vista Business
Battery Life	Up to 6 hours
Wireless	Intel PRO/Wireless 3945ABG or 4965AGN
Dimensions	28.2 x 21.4 x 2.35 cm
Ports	3 USB 2.0, VGA, headphone/microphone jacks, docking connector
Optical Drive	External (optional)