To Next Page

To Previous Page

A-10

Specifications

Twisted-Pair Cable/Connector Pin-Outs

■ For 100 Mbps connections to the ports, use 100-ohm Category 5 UTP or

STP cable only, as supported by the IEEE 802.3u Type 100BASE-TX

standard.

■ For 1000 Mbps connections, 100-ohm Category 5e or better cabling is

recommended.

■ To provide Power over Ethernet to the access point, all 4 pairs must be

connected for any network cable attached to this port; the cable must

meet ISO/DIS 11801 Class D requirements and IEEE 802.3af requirements.

Questions and Answers:

Need help?

Do you have a question about the HP 2530-24 and is the answer not in the manual?

HP 2530-24 Specifications

General