To Next Page

To Previous Page

2-21

Installing the Switch

Installation Procedures

Figure 2-11. Connecting a console cable

2. Turn on the terminal or PC’s power and, if using a PC, start the PC terminal

program.

3. Press

[Enter] two or three times and you will see the copyright page and

the message “Press any key to continue”. Press a key, and you will then

see the switch console command (CLI) prompt, for example:

HP-2530-24G-PoEP#

If you want to continue with console management of the switch at this time,

see chapter 3, “Getting Started With Switch Configuration” for some basic

configuration steps. For more detailed information, refer to the Management

and Configuration Guide, which is on the HP Web site at

www.hp.com/networking/support.

Optional USB

Console cable

(not supplied)

Connect to a PC

running a terminal

emulator program, or

a VT-100 terminal

RJ-45 to DB9

Console cable

supplied with

the switch

Console port

Questions and Answers:

Need help?

Do you have a question about the HP 2530-48G and is the answer not in the manual?

HP 2530-48G Specifications

General