Detail: defaultTaskParameter
Default threshold setting when
enabled: 1000 (med)
The number of destination IP
addresses learned in the IP
forwarding table.
[ip-address-count]
Default threshold setting when
enabled: 100 (med)
The number of MAC address learn
events per minute discarded to help
free CPU resources when busy.
[learn-discards]
Default threshold setting when
instrumentation monitoring is
enabled: enabled
Enables/disables instrumentation
monitoring log so that event log
messages are generated every time
there is an event that exceeds a
configured threshold.
[log]
Default threshold setting when
enabled: 10 (med)
The count of failed CLI login
attempts or SNMP management
authentication failures per hour.
[login-failures]
Default threshold setting when
enabled: 1000 (med)
The number of MAC addresses
learned in the forwarding table.
[mac-address-count]
You must enter a specific value in
order to enable this feature.
Default threshold setting when
enabled: 100 (med)
The average number of MAC
address moves per minute from one
port to another.
[mac-moves]
Default threshold setting when
enabled: 10 (med)
The count of packets per minute
sent to closed TCP/UDP ports.
[pkts-to-closed-ports]
Default threshold setting when
enabled: 10 (med)
The count of times per minute that
a client has been unsuccessful
logging into the network.
[port-auth-failures]
Default threshold setting when
enabled: 3 seconds (med)
The response time, in seconds, of
the CPU to new network events
[system-delay]
such as BPDU packets or packets
for other network protocols.
Default threshold setting when
enabled: 50 (med)
The percentage of system resources
in use.
[system-resource-usage]
Default setting when instrumentation
monitoring is enabled: disabled
Enables or disables SNMP trap
generation.
[trap]
To enable instrumentation monitoring using the default parameters and thresholds, enter the
instrumentation monitor command. To adjust specific settings, enter the name of the
parameter to modify and revise the threshold limits as needed.
Examples:
To turn on monitoring and event log messaging with the default medium values:
HP Switch(config)# instrumentation monitor
To turn off monitoring of the system delay parameter:
HP Switch(config)# no instrumentation monitor system-delay
To adjust the alert threshold for the MAC address count to the low value:
HP Switch(config)# instrumentation monitor mac-address-count low
To adjust the alert threshold for the MAC address count to a specific value:
HP Switch(config)# instrumentation monitor mac-address-count 767
To enable monitoring of learn discards with the default medium threshold value:
28 Updates for the HP Switch Software Access Security Guide
To Next Page
Loading...
Need help?
General
