1. Enter the following in the FreeRADIUS dictionary.hp file:
• HP vendor-specific ID
• ACL VSA for IPv6 ACLs (63)
• HP-Nas-Rules-IPv6 VALUE setting to specify both IPv4 and IPv6 (1)
Figure 8 Example: Configuring the VSA for RADIUS-assigned IPv6 and IPv4 ACLs in a
FreeRADIUS server
2. Enter the switch IPv4 address, NAS type, and the key used in the FreeRADIUS clients.conf file.
For example, if the switch IP address is 10.10.10.125 and the key ("secret") is "1234", enter
the following in the server's clients.conf file:
Figure 9 Example of switch identity information for a freeRADIUS application
48 Updates for the HP Switch Software Access Security Guide
To Next Page
Loading...
