HP 2920 Series User Manual

The group keyword can be used to show a list of ports where a particular multicast
group is registered.
The group keyword can be used to show VLAN-ID, group address, uptime,
expiration time, last reporter and hardware filter type information for each group.
When followed by VLAN keyword and VLAN-ID, it displays the VLAN group
address, uptime, expiration time, last reporter and multicast filter type for groups
that belong to that VLAN-ID.
Output:
IGMP Service Protocol Info
Total VLANs with IGMP enabled : 0
Current count of multicast groups joined : 0
IGMP Filter Unknown Multicast: Disabled
IGMP Filter Unknown Multicast Status: Disabled
VLAN ID : 1
VLAN Name : DEFAULT_VLAN
IGMP version : 2
IGMP is not enabled
Syntax:
show ip igmp vlan <ID> group <group-address>
Shows IGMP group information for the specified VLAN.
Output:
IGMP ports and group information for group 239.0.2.1
VLAN ID: 2
Uptime: 0h 0m 47s
Last Reporter: 10.20.30.255
Type: Filter
Port Port Type Port Mode Expires Access
------ --------- --------- ------- ---------
A2 1000T Auto 214 host
Syntax:
show ip igmp vlan <ID> config
Shows IGMP configuration information for the specified VLAN.
Output:
IGMP Service VLAN Config
VLAN ID : 1
VLAN Name : DEFAULT_VLAN
IGMP Enabled [No] : No
Querier Allowed [Yes] : Yes
Querier Interval [125] : 125
Syntax:
show ip igmp vlan <ID> counters
Shows information about IGMP counters for the specified VLAN.
34 Multimedia Traffic Control with IP Multicast (IGMP) v2 NG

HP 2920 Series Specifications

General

Brand	HP
Model	2920 Series
Category	Switch
Language	English