Before
You
Install
...
1.
Obtain
the
tape
cartridge
for release 7.0
of
HP-UX.
This
tape
is labeled as
follows:
HP9000
Series
300
HP-UX
INSTALL
TAPE
Release
0700,
VUF
A.B7.00,
INSTALL
format
DC600
Cart
1
of
1
2.
Have a
properly
configured
and
tested
hardware
system
as follows:
Computer
Series 300, Model 318, 319, 320, 330, 332, 340, 350, 360, 370,
or
375 (Model 310 is
no
longer
supported).
Disk drive
At
least
one
hard
disk drive (for example,
an
HP
7958
or
HP
7937/7936) with:
•
approximately
80
Mbytes
minimum
disk space.
•
at
least 130
Mbytes
recommended
for a
workstation.
•
at
least 300
Mbytes
recommended
for a
cluster
server.
Tape
drive A
tape
drive
that
uses
an
HP
Certified
Data
Cartridge
(for
example,
an
HP
9144).
RAM
At
least
4 Mbytes; 8
Mbytes
recommended. For a
cluster
server,
at
least 8 Mbytes; 16
Mbytes
recommended.
For
more
information
on
a
properly
configured system, see available
hardware
configuration
manuals
and
data
sheets, such as
the
HP9000 Series
300 Hardware Configuration Guide.
3.
When
you finish
Steps
1
and
2,
above, go
on
to
Chapter
2.
A
typical
installation
takes
4
to
6 hours,
depending
on
how
much
software you load.
Introducing Series 300 7.0 HP-UX Installation 1-7
To Next Page
Loading...
