Step
5:
Select the Destination Device
You should see
the
Destination Menu, below (if you do
not
see
this
menu,
something is wrong. Unload
the
install
tape
from
the
tape
drive, remove
the
tape,
turn
everything
OFF,
and
start
the
process again):
HP-UX
INSTALLATION
UTILITY
--
DESTINATION
MENU
Select
one
of
the
following
disks
(name
and system
location)
..
,
Disk
Search
Again
Other
disk
Select
Bus
Unit
Code
Addr
Num
,
Select
,
,
Item ,
Selecting the Destination
Vol
Num
,
Exit
'Install
The
Destination
Menu lists all connected disks, including
the
disk's select
code, bus address,
unit
number,
and
volume number. From
the
Destination
Menu, select
the
destination disk
(that
is,
the
disk on which you
want
to
install
HP-UX) as follows:
1.
Using
the
arrow keys, move
the
highlight
bar
until you've highlighted
the
name
of
the
disk
that
will
be
the
destination disk.
2.
Press
either
"Select Item"
(®)
or
[Return ).
Installing the HP-UX Operating System 2-7
To Next Page
Loading...
