HP 300 Series - The Destination Disk Is Not Listed

The Destination Disk Is Not Listed
If you do not see your destination disk listed on the menu, make sure the disk
is connected properly
and turned on. Then follow these steps:
1. Select the "Search Again" option.
2. If you still don't see your destination disk listed on the Destination Menu,
select
the "Other disk" option.
3. Type in the correct information:
• Major number (0 for HP-IB/CS80 disks; 7 for SCSI disks)
• Select code (set on the interface card connected to the disk; usually 14 for
high speed
HP-IB or SCSI, or 7 for standard HP-IB)
• Bus address (set on the disk with DIP switches or a rotary switch; usually
0)
• Unit number (usually 0)
• Volume number (usually 0)
4. Press (Return 1. You should see your destination device listed on the
Destination Menu. Use the arrow keys to highlight the disk, and press
"Select Item" .
2-8 Installing the HP-UX Operating System