Tasks to Complete
af.t.er
Installation
Once
you've installed
the
operating
system, you
can
start
providing for your
users.
You need
to
complete
the
following
tasks
right
away:
1.
Review
/tmp/update
.log.
2.
If
you
started
the
install
with
an
old
operating
system
(HP-UX
6.2
or
earlier),
restore
any files you saved before you
began
the
installation.
3.
Add
users
to
the
system
by
running
/usr
/bin/
sam.
4.
If
the
system
is
to
be
a
cluster
server, use
/usr/bin/sam
to
convert
it
to
a
cluster
server
and
add
cnodes.
For
information
on
restoring
files,
adding
users,
and
converting
the
system
to
a
cluster
server, see
the
System
Administration Tasks Manual.
Depending
on
the
software you loaded, you
may
also need
to
complete
these
tasks:
•
1.
Configure networking
and
applications. You
might
have
loaded
then1
during
the
installation
process,
or
you
might
need
to
load
them
separately
using /
etc/update.
For configuration details, refer
to
the
documentation
for
those
subsystems. For
information
on
/
etc/update,
see
the
System
Administration Tasks Manual.
2.
Configure
the
system
for
the
XII
windowing
system
if you loaded
it
during
installation
(see Installing X on the Series 300).
3.
Install
peripherals
(see Installing Peripherals).
Regarding
these
tasks, you
might
have various questions:
•
Where
do I get
related
information?
• How do I
administer
an
HP
-
UX
system?
•
What
constitutes
efficient use
of
an
HP-UX
system?
• How do I
backup
the
system
and
support
users?
The
manuals
for
system
administration
and
for
particular
applications
or
subsystems
will help answer
most
of
these
questions. For
the
documentation
to
help you
manage
and
use
HP-UX,
see
the
manual
Finding HP- UX Information
(Series 300).
3-2 Initial Configuration of HP-UX
To Next Page
Loading...
