HP 300 Series - Change DESTINATION Device; Change FILESYSTEM Parameters

Change DESTINATION device ...
Select this option if you are not satisfied with the current destination. To
change to a different destination device, proceed as follows:
1. Use the arrow keys to highlight this option:
Change DESTINATION device ...
2. Press "Select Item" , which returns you to the Destination Menu. Follow the
instructions in "Step 5: Select the Destination Device." From this menu,
you also
can return to the Main Menu (@) or you can exit install (@).
Change FILESYSTEM parameters ...
The installation process initializes the file system (the disk) using default
parameters suitable for most HP-UX use. Do not change the values for file
system parameters unless you have expert knowledge of HP-UX and know why
you need
to change them.
If you do need to change the parameters, proceed as follows:
1. Use the arrow keys to highlight this option:
Change FILESYSTEM parameters .,.
2. Press "Select Item" , which brings up the Filesystem Parameters Menu. To
change file system parameters, follow these steps:
a.
Use the arrow keys to highlight the parameter you want to change.
(Typically,
the only parameter you might need to change is "swap space";
see the following page for a discussion of swap space.)
b. Type the new parameter value; the value appears at the bottom of your
display for verification.
c.
Press (Return) to verify the value you just typed. Changes are immediate.
d. When you have changed all necessary file system parameters, press
"Done" (@). You will return to the Main Menu, illustrated on the
facing page.
Go on to Step 7.
Installing the HP-UX Operating System 2-11