HP photosmart 318 User Guide32
To connect the camera to a Windows computer
1 Make sure the camera is turned off.
2 Plug the smaller end of the USB cable into the camera.
3 Plug the flat end of the cable into any USB port on your
computer.
Note When the camera is connected to your computer,
only the switch operates. The other
camera buttons do not respond.
Unloading images to a Windows computer
Unloading is the process of copying images from the camera’s
memory to your computer. If you have a CF memory card installed
in the camera, images will be copied from the CF memory card to
the computer.
You can unload images from your camera in one of three ways:
automatically, manually, or by mounting the camera as a disk
drive. The automatic unload procedure is the preferred method.
For descriptions of the other methods, see the online
documentation with the HP Photo Imaging software.
Tip To conserve battery power, you can use an AC
adapter (optional) when you are unloading images
to your computer.
To unload images automatically
1 Connect the camera to your computer using the USB cable.
2 Turn the camera on.
SJUG.book Page 32 Tuesday, October 9, 2001 1:35 PM
To Next Page
Loading...
