HP 3468A - Page 74

REMOTE
Examples
REMOTE 9
REMOTE 901
Comments
As a general rule, the command REMOTE 9 should be executed at the beginning
of each program. This ensures that the controller has reassigned addresses for
each device. The REMOTE command is used to enable the 3468A to switch from
local front panel control to remote program control. The 3468A must actually be
addressed before it will go into its Remote state.
The Remote state for the 3468A means that the front panel keyboard (except the
LOCAL and SRQ keys) is disabled. The RMT annunciator in the display is turned
on, The 3468A remains in the same state after it receives the REMOTE command
that it was in before receiving it. To disable the LOCAL and SRO keys use the
LOCAL LOCKOUT command.
70