HP 39gII - Page 305

Programming 295
AngleA The measure of angle A. Sets the measure of angle A.
The value of this variable will be interpreted according to
the angle mode setting (Degrees or Radians). From
the Triangle Solver Numeric view, enter a positive value
for A.
Or, in a program, type:
AngleA
where
AngleB The measure of angle B. Sets the measure of angle B.
The value of this variable will be interpreted according to
the angle mode setting (Degrees or Radians). From
the Triangle Solver Numeric view, enter a positive value
for B.
Or, in a program, type:
AngleB
where
AngleC The measure of angle C. Sets the measure of angle C.
The value of this variable will be interpreted according to
the angle mode setting (Degrees or Radians). From
the Triangle Solver Numeric view, enter a positive value
for C.
Or, in a program, type:
AngleC
where
RECT Corresponds to the status of in the Numeric view of
the Triangle Solver app. Determines whether a general
triangle solver or a right triangle solver is used. From the
Triangle Solver view, press .
Or, in a program, type:
0
RECT—for the general Triangle Solver
1
RECT—for the right Triangle Solver
Modes variables These variables are found in the Symbolic setup of an
app. They can be used to overwrite the value of the
corresponding variable in Home Modes.
n
n 0>
n
n 0>
n
n 0>