HP 410

hp digital copier printer 410
chapter 2
12
set the paper type and size
If you want to use a different type of paper, such as photo paper or transparency
film, simply load that paper in the main tray. The HP Digital Copier Printer’s
automatic media sensor automatically selects the paper type and size for your
print job; however, you can also choose your own paper-type and paper-size
settings to ensure the best print quality.
For information on changing your print settings manually, see select paper type
on page 16 or select paper size on page 19.
4” x 6” photo paper Insert the photo paper, print side down, into the paper tray until it stops.
Place the long edge of the photo paper against the right side of the paper
tray, slide the paper-width guide up against the long edge of the photo
paper, and then slide the paper-length guide in until it stops. If the photo
paper you are using has perforated tabs, load the photo paper so the tabs
are closest to you.
Continuous (banner)
paper
Continuous banner paper is also known as computer or z-fold paper.
• Before loading banner paper, remove all other paper from the paper
tray, then remove the output tray.
• If you use non-HP banner paper, use 20-lb. paper, and fan the paper
before loading it.
• Verify that the stack of banner paper contains at least five pages in the
stack.
• Carefully tear off the perforated edge strips from both sides of the
paper stack, if any, and unfold and refold the paper to make sure the
pages do not stick together.
• Put the paper in the paper tray so the unattached edge is at the top of
the stack. Insert the first edge into the paper tray until it stops, as
shown in the illustration above.
paper tips
Remove the output
tray.
Insert the unattached
edge of the paper into
the paper tray.