Index – 5
switch
connecting to a power source … 2-21
description … 1-1
electrical specifications … A-1
environmental specifications … A-2
included parts … 2-1
mounting in a rack or cabinet … 2-17
mounting on a horizontal surface … 2-20
physical specifications … A-1
switch chassis
LED descriptions … 1-10
switch modules
booting the switch to initialize changed module
type … 2-9
hot swapping … 2-27
installing … 2-8
LEDs descriptions … 1-13
list of available types … 1-22
switch operation
verifying after installation … 2-14
Switch Setup screen … 3-2
configuring a subnet mask … 3-3
configuring an IP address … 3-3
field descriptions … 3-3
T
telnet access to the console … 2-26, 3-5
terminal configuration … 2-23
testing
checking the console messages … 5-12
checking the LEDs … 5-12
diagnostic tests … 5-11
end-to-end communications … 5-13
link test … 5-13
Ping test … 5-13
switch operation … 5-11
switch-to-device communications … 5-13
twisted-pair cabling … 5-13
tips for troubleshooting … 5-2
topologies
effects of improper topology … 5-2
Transceivers
indications of unsupported … 5-7
transceivers
hot swap feature … 1-24
troubleshooting … 5-1
basic tips … 5-2
checking port configuration … 5-3
checking the console messages … 5-12
checking the LEDs … 5-12
common network problems … 5-2
connecting to fixed full-duplex devices … 5-3
diagnostic tests … 5-11
effects of improper topology … 5-2
effects of non-standard cables … 5-2
link test … 5-13
Ping test … 5-13
Proactive Network tools … 5-10
restoring factory default configuration … 5-14
testing connections to other devices … 5-13
testing end-to-end communications … 5-13
testing the switch … 5-11
testing the twisted-pair cables … 5-13
twisted-pair cable
crossover cable pin-out … B-12
pin-outs … B-8, B-10, B-15
straight-through cable pin-out … B-10, B-15
switch-to-computer connection … B-10, B-14
switch-to-switch or hub connection … B-12
testing … 5-13
twisted-pair ports
HP Auto-MDIX feature … B-8
W
wiring rules for twisted-pair cables … B-8
To Next Page
Loading...
Need help?
General