Figure 5 Move retaining bracket to back
5. After attaching the rail, grab and move the rail gently to be sure it is firmly engaged in the rack
and that all latches are engaged in the rack holes.
6. Repeat Step 1 through Step 5 for the left rail.
Installing the disk enclosure
1. Remove the bezel covers from each side of the enclosure (see Figure 6 (page 6)).
CAUTION: Be careful when removing the bezel covers so as to not break the locking tabs that
secure the covers to the enclosure.
Figure 6 Remove bezel cover
2. Align the enclosure with the rails and slide it into the rack.
6 Installing the disk enclosure
To Next Page
Loading...
