HP 654 A Series - Series 657 xA Specifications

Table 1-2a. Performance Specifications for Series 657xA (Note 1)
Parameter
HP 6571A
HP 6572A
HP 6573A
HP 6574 A
HP 6575A
Specifications are warranted over the temperature range 0 to 55® C with a resistive load and the output
local sensing.
connected for
Output Ratings
Voltage:
Current:
0-8 V
0 - 220 A
0 - 20 V
0 - 100 A
0-35 V
0-60 A
0.60 V
0-35 A
0 - 120 V
0 - 18 A
Front Panel Programming.Acc
Voltage:
Current:
jracy (® 25® C
0.047o+8 mV
0.11%-|-125mA
± 5® C)
0.04%+20 mV
0.11%+60mA
0.04%+35 mV
0.11%+40mA
0.04%+60 mV
0.11%+25 mA
0.04%+120 mV
0.11% 12 mA
Ripple Noise (from 20 Hz to
grounded)
Constant Voltage (rms);
Constant Voltage (p-p):
Constant Current (rms):
20 MHz with
650 /iV
7 mV
200 mA
sutputs ungrou
760 mV
9 mV
100 mA
nded, or with
800 mV
9 mV
40 mA
either output t
1.25 mV
11 mV
25 mA
erminal
1.9 mV
16 mV
12 mA
Readback Accuracy (with resp^
Voltage;
Current:
2 ct to actual ou
0.05%+12 mV
0.1%-f-150mA
tput (ffi 25® C :
0.05%+30 mV
0.1%+100 mA
k 5® C)
0.05%+50 mV
0.1%+60mA
0.05%-|-90 mV
0.1%+35 mA
0.05%+180 mV
0.1%+18 mA
Load Regulation (change in out
Voltage:
Current:
put voltage or
0.002%+300 mV
0.005%-f-lO mA
current for an:
0.002%+650 mV
0.005%+7 mA
' load change v
0.002%+1.2mV
0.005%+4 mA
dthin ratings)
0.002%-|-2 mV
0.005%+ 2 mA
0.002%+4 mV
0.005%+ 1 mA
Line Regulation (change in out
Voltage:
Current:
3ut voltage or (
0.002%-f300/iV
0.005%+10 mA
:urrent for any
0.002%+650mV
0.005%-f 7 mA
line change wi
0.002%+1.2mV
0.005%-|-4 mA
thin ratings)
0.002%+2 mV
0.005%+2 mA
0.002%+4 mV
0.005%+! mA
Transient Response Time
<900 ^S for the output voltage to recover to within 100 mV foUo
diange in load current from 100% to 50% or 50% to 100% of the i
iving any step
ated current.
AC Input Ratings (selectable v
Nominal line voltage
200 Vac:
(Below 185 Vac, derate output
voltage linearly to:)
230 Vac:
Frequency range:
a internal swit
7.8 V
:hing - see App
18.0 V
)endix B)
174-220 Vac
31.5 V
191-250 Vac
47 - 63 Hz
56.5 V
108 V
Output Terminal Isolation
±240 Vdc (maximum, from output sismal eroundl
Note 1: For Supplemental Characteristics, see Table l-2b.
Specifications
Series 657xA
General Information
1-11