HP 7 Pro 740pm Series User Manual

20
3) Lift the USB-B connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
Solder the new component
RJ45 connector RJ1
Repair the RJ45 connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Lift the RJ45 connector from the PCB.
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component.
USB-A connector USB3/USB4
Repair the USB-A connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Lift the USB-A connector from the PCB.
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component.

HP 7 Pro 740pm Series Specifications

General

Brand	HP
Model	7 Pro 740pm Series
Category	Monitor
Language	English