HP 95LX - Page 99

Transferring Files with a Modem
To transfer files using XMODEM protocol:
1. Set the configuration settings needed by the host system except: always set 8
bits/character (press (Settings, (Config, (Port, (Char, (8).
Connect to the host (see page 98): Press (MENU), (Connect; log on, as needed.
On the host, run a program that uses XMODEM protocol.
Tell the host program to: Send (if you're downloading to the HP 95LX); or
Receive (if you're uploading to the host).
On the 95LX, press: (MENU), (Transfer, X]MODEM, (Receive (if downloading) or
(MENU), (Transfer, X)(MODEM, (Send (if uploading). Enter the filename(s).
Once the transfer finishes, any key clears the screen. Then CTRU-F7) (REIREED).
To transfer files using Kermit protocol:
1.
Ok
LN
Set the configuration settings needed by the host system—except as follows: If
Par it yis None, set 8 bits/character (press (Skttings, (Config, Port, (Char,
(8); If Parity is Even, Odd, Mark, or Space, set 7 bits/character.
Connect to the host (see p. 98): Press (MENU), (Clonnect. Then log on, if necessary.
Run the communications program on the host that can use the Kermit protocol.
Execute the host Kermit-Server command to place the host into server mode.
On the HP 95LX, press: (MENU), (T)ransfer, (Kermit, (Glet (if downloading) or
(MENU), (Transfer, X]IMODEM, (Send (if uploading). Enter a filename(s).
Once the transfer is complete, press any key to clear the screen, and then press
(MENU), (T)ransfer, (Kermit, (Dogout, (EW=INTS).
To upload ASCII Text files without a protocol:
~w N=
Set the configuration settings needed by the host system.
Connect to the host (see page 98): Press (MENU), (Clonnect; log on, as needed.
Redirect the host’s input from the keyboard to the serial port (i.e. {<COM1).
If necessary, press (MENU), (T)ransfer, (Tlext, (Options to set the Throttling and
Pacing for the transfer mode (characters are transferred at the Throttling rate
until a newline character is sent, at which point the next line of characters is
not sent until the Pacing conditions are met).
5. Onthe95LX: (MENU), (T)ransfer,(Tlext,(Slend (ifuploading). Enter the filename(s).
After the transfer: (A), MENU), (T)ransfer, (Kermit, (Logout, (=EI=T0=).
Using a Modem 99