9. If you are replacing the VFD customer display, slide the new customer display into the slot on the
hinge (1) and insert the two screws that secure it in place (2).
Figure 2-16 Replacing the VFD Customer Display
10. Attach the hinge bracket cover by placing the upper sides of the cover over the sides of the bracket
(1) then pressing the bottom of the cover onto the bracket so that it snaps in place (2).
Figure 2-17 Replacing the VFD Hinge Bracket Cover
11. Replace the bottom I/O cover (see Replacing the Bottom I/O Cover on page 6).
12. Reconnect the power cord and press the power button.
13. Configure the new customer display (refer to
Configuring the MSR and VFD Customer Display
on page 27).
ENWW Removing and Replacing the VFD Customer Display 15
To Next Page
Loading...
