9. Remove the five screws that secure the display head to the display head housing. Two of the
screws are located under the bottom I/O cover. The third screw is located under the drive cover.
The fourth screw is located under the MSR. The fifth screw is located below the touch screen
hinge.
NOTE: Some models may have only four screws. The center screw shown below may not be
included.
Figure 2-27 Removing the Display Head Screws
10. Lift the bottom side of the display head housing (where the two screws were removed) off the touch
screen (1), then lift the top side off the housing off the touch screen (2).
Figure 2-28 Removing the Display Head
11. Locate the memory module sockets on the system board.
WARNING! To reduce risk of personal injury from hot surfaces, allow the internal system
components to cool before touching.
24 Chapter 2 Hardware Upgrades ENWW
To Next Page
Loading...
