Upgrading Your System
Removing and Replacing the System Board
Installing the new System Board
1. Position the system board tray in the new chassis. When it is flat in the workstation, align the system
board tray’s keyholes with the standoffs on the side wall of the chassis, and then slide the system board
tray toward the back of the workstation to seat the standoffs into their corresponding keyholes.
2. Replace the two T-15 Torx screws that secure the system board tray to the rear wall of the workstation.
3. Place the old system board tray into the protective packaging from the new replacement system board and
put it aside.
22
Chapter 2
To Next Page
Loading...
Need help?
General