Getting Started
Upgrade Instructions Overview
Upgrade Instructions Overview
The general steps for performing the upgrade are outlined as follows and should be
performed in the sequence listed. Refer to the individual sections of this guide for the
actual step-by-step procedures for upgrading your system.
1. Prepare your workstation
- Verify that you have the correct version of HP-UX.
- Determine and WRITE DOWN the LAN ID of your system. You may need to
re-enter it in the new system board.
- Power off the workstation and any peripherals.
- Unplug the power.
2. Remove the Current Bezel Label and Attach New Labels
3. Remove the terminators and cables.
4. Remove the side panel.
5. Remove the power supply.
6. Remove the hard disk fan.
7. Remove the memory cards (DIMMs).
8. Remove the air divider.
9. Remove the PCI I/O card(s).
10. Disconnect the system board cables.
11. Remove the old system board.
12. Install the new system board.
13. Reconnect the system board cables.
14. Reinsert the PCI I/O card(s).
15. Reinstall the air divider.
16. Reinsert the memory cards (DIMMs).
17. Reinstall the hard disk fan.
18. Reinstall the power supply.
19. Replace the left side panel.
20. Verify system operations.
Chapter 1
5
To Next Page
Loading...
Need help?
General