Introduction
1–6
Preparing to Install the CD-ROM Drive
The following information is provided to prepare the CD-ROM for installation.
Tools Required
The following tools are needed to install the CD-ROM drive:
• #2 Phillips screwdriver
• Small needlenose pliers
Verifying Kit Contents
Verify that the kit contains one of each of the following:
• CD-ROM drive (drive P/N A4xxx–60001)Aa,
• Set of 4 screws (M4x6)
• Power adapter cable
• SCSI I/O cable
• Static strap
• HP 12x Speed CD-ROM Disk Drive User’
s Guide
(A1658–90703)
NOTICE: If any contents of your kit are missing, contact your sales
representative.
Minimum Requirements
Minimum requirement for the HP-UX operating system is level 9.03 for the HP 12x
Speed CD-ROM drive.
NOTICE: ****You must use software patch PHSS_6620 under HP-UX
9.03, 9.05 and 9.07 and software patch PHSS_6607 under HP-
UX 10.01 to run SupportW
ave successfully
.***???Aa,
To Next Page
Loading...
Need help?
General
