7. Use a thin plastic tool (1) to separate the rear edge of the keyboard/top cover (2) from the bottom cover.
8. Position the computer right side up with the rear toward you.
9. Open the computer as far as it will open.
10. Lift the rear edge of the keyboard/top cover (1) as far as the keyboard cable and touchpad cable allow.
11. Release the zero insertion force (ZIF) connector (2) to which the touchpad board cable is connected, and
then disconnect the touchpad cable from the system board.
12. Release the shielding (3) that covers the keyboard cable ZIF connector.
13. Release the ZIF connector (4) to which the keyboard cable is connected, and then disconnect the keyboard
cable from the system board.
26 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
