Control panel
1. Remove the control-panel bezel. See Control-panel bezel on page 124.
2. Release one tab (callout 1) and then slide the control panel toward the left side of the product to
release it.
Figure 6-6 Remove the control-panel (1 of 2)
1
3. Rotate the control panel up and off of the product, and then disconnect two FFCs (callout 2).
NOTE: The base model only has one FFC.
Figure 6-7 Remove the control-panel (2 of 2)
2
ENWW Control panel 125
To Next Page
Loading...