2. Lower the Tray 1 paper pickup assembly by pushing down on the edges of the assembly.
Figure 6-17 Remove the Tray 1 paper-pickup roller (1 of 3)
3. Carefully raise the front of the product.
WARNING! Do not place the product face-up resting on the rear cover and rear door. Excess
toner might enter the laser/scanner assembly and contaminate the mirrors, causing print-quality
problems. The laser/scanner is not a FRU. If the laser/scanner mirrors are contaminated, the entire
product must be replaced.
CAUTION: Do not lift the product grasping the front door and Tray 2 cavity.
Figure 6-18 Remove the Tray 1 paper-pickup roller (2 of 3)
ENWW Paper-feed rollers and pads 135
To Next Page
Loading...