5. Carefully lift up on the front of the ITB to release it.
CAUTION: Avoid touching the black plastic transfer belt. Skin oils on the belt might cause print-
quality problems. Lift the ITB as shown below, by using the hard-plastic edges of the ITB.
Figure 6-32 Remove the ITB (4 of 6)
6. Open the rear door, and carefully lift up on the sheet-metal portion (callout 3) of the ITB to release
it.
CAUTION: Avoid touching the black plastic transfer belt. Skin oils on the belt might cause print-
quality problems.
NOTE: You might need to reach in through the front door and support the front portion of the ITB
to keep it from falling back into place as you perform this step.
Figure 6-33 Remove the ITB (5 of 6)
3
144 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...