Motors (drum motor and developer motor)
This procedure can be used to remove the drum motor (M1) or the developer motor (M2). HP does not
recommend removing both of the motors at the same time.
1. Remove the right cover. See
Right cover on page 156.
2. Disconnect one connector (callout 1) for motor M1 or motor M2.
NOTE: The drum motor (callout 2) is motor M1. The developer motor (callout 3) is motor M2.
Figure 6-36 Remove motor M1 and motor M2 (1 of 3)
1
2
3
3. Release the wire harnesses from the retainer, and then release one tab (callout 4). Move the
retainer (callout 5) to one side (you will not be able to completely remove the retainer from the
product).
Figure 6-37 Remove motor M1 and motor M2 (2 of 3)
4
5
ENWW Components and major assemblies 147
To Next Page
Loading...