Reinstall the upper-cover assembly
1. Position the upper-cover so that the front-left corner of the upper cover engages the left-side cover
(callout 1).
Figure 6-97 Reinstall the upper-cover assembly (1 of 3)
1
2. Slightly push the cover toward the front of the product to engage the front-locking tabs (callout 2)
with the holes in the chassis.
NOTE: Make sure that the right-front edge of the upper cover (where the product right-front cover
will be installed) is correctly positioned on the chassis.
Figure 6-98 Reinstall the upper-cover assembly (2 of 3)
2
ENWW Components and major assemblies 183
To Next Page
Loading...