Color-misregistration sensor assembly
1. Remove the following components:
●
Right cover. See
Right cover on page 156.
●
Scanner assembly. See
Scanner assembly on page 163.
●
Simplex products
◦
Rear door. See
Rear door (simplex product) on page 152.
◦
Rear cover. See
Rear cover and feed guide (simplex product) on page 166.
●
Duplex products
◦
Rear-lower cover. See
Rear-upper cover (duplex product) on page 165.
●
Upper-cover assembly. See
Upper-cover assembly on page 181.
●
Left cover. See
Left cover on page 185.
●
High-voltage power-supply PCA. See
High-voltage power-supply PCA on page 189.
2. Disconnect one connector (callout 1), and then release the wire harness from the guide (callout 2).
Figure 6-111 Remove the color-misregistration sensor assembly PCA (1 of 5)
1
2
192 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...