4. Slide the cover slightly toward the right side of the product to release it.
NOTE: For fax/memory-card models only: When the sliding the cover, do not damage the FFC
guide (callout 3).
Figure 6-122 Remove the right-front cover and power button (3 of 5)
3
5. Remove the cover.
NOTE: For all models: If you are replacing the right-front cover, proceed to the following step
and remove the power button. Install the power button on the replacement cover.
For base models only: If you are replacing the right-front cover remove the blanking cover and
install it on the replacement cover.
For fax/memory-card models only: If you are replacing the right-front cover remove the memory-
card cover and PCA, and then install them on the replacement cover. See
Memory-card cover and
PCA (fax/memory-card models) on page 200.
Figure 6-123 Remove the right-front cover and power button (4 of 5)
198 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...