8. Rotate the memory-card PCA away from the cover to release it, and then remove the PCA.
NOTE: Before you remove the PCA, look at how it is installed in the cover. There are two tabs
along the side of the opening in the cover that retain the PCA when the memory-card cover is
installed. The PCA fits over the bottom tab, and behind the upper tab.
Figure 6-131 Remove the memory-card cover and PCA (7 of 7)
Reinstall the memory-card cover and PCA
1. Install the memory-card PCA and hold it in place on the cover.
2. Insert the tabs on the bottom of the PCA cover into the slots on the right-front cover.
Figure 6-132 Reinstall the memory-card cover and PCA (1 of 2)
ENWW Components and major assemblies 203
To Next Page
Loading...