HP Color LaserJet CM2320 - Multifunction Printer - Page 224

Duplex-reverse drive assembly
1. Remove the following components:
●
Right cover. See
Right cover on page 156.
●
Scanner assembly. See
Scanner assembly on page 163.
●
Simplex product
◦
Rear door. See
Rear door (simplex product) on page 152.
◦
Rear cover. See
Rear cover and feed guide (simplex product) on page 166.
●
Duplex product
◦
Rear-upper cover. See
Rear-upper cover (duplex product) on page 165.
◦
Rear door. See
Rear door (duplex product) on page 154.
◦
Rear-lower cover. See
Rear-lower cover and rear-door links (duplex product)
on page 170.
●
Upper-cover assembly. See
Upper-cover assembly on page 181.
2. Disconnect two connectors (callout 1), and then pass the connectors under the rear-door rib
assembly.
Figure 6-146 Remove the duplex-reverse drive assembly (1 of 4)
1
212 Chapter 6 Removal and replacement ENWW