Fuser
WARNING! The fuser might be very hot. After turning off the product power, allow the fuser to cool
for at least 5 minutes before removing it.
NOTE: The fuser can be removed without removing the scanner assembly and the upper-cover
assembly. However, it might be easier to access some of the connectors with these components
removed.
1. Remove the following components:
●
Right cover. See
Right cover
on page
156.
●
Scanner assembly. See
Scanner assembly
on page
163.
●
Simplex product
◦
Rear door. See
Rear door (simplex product)
on page
152.
◦
Rear cover. See
Rear cover and feed guide (simplex product)
on page
166.
●
Duplex product
◦
Rear-upper cover. See
Rear-upper cover (duplex product)
on page
165.
◦
Rear door. See
Rear door (duplex product)
on page
154.
◦
Rear-lower cover. See
Rear-lower cover and rear-door links (duplex product)
on page
170.
●
Upper-cover assembly. See
Upper-cover assembly
on page
181.
●
Left cover. See
Left cover
on page 185.
ENWW Components and major assemblies 215
To Next Page
Loading...