6. Carefully disconnect one connector and rotate the connector and the top portion of the guide away
from the fuser (callout 5).
WARNING! Do not separate the connector and guide more than is shown in Figure 6-153
Remove the fuser (4 of 8) on page 217. If the guide is damaged, you must replace the fuser. Also,
be cautious with the short, fragile connector.
Figure 6-154 Remove the fuser (5 of 8)
5
7. Remove two screws (callout 6).
Figure 6-155 Remove the fuser (6 of 8)
6
218 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...