HP Color LaserJet CM3530 - Page 31

5. Release bracket that holds the hard drive, and swing it open.
X
IO
X
IO
X
I
X
O
O
X
I
X
O
X
IO
X
I
O
X
IO
X
IO
X
IX
O
O
X
I
X
O
X
IO
X
IO
X
IO
X
IO
X
IX
O
O
X
I
X
O
X
IO
X
IO
X
I
O
X
IO
X
I
X
O
O
X
I
X
O
X
I
O
X
IO
6. To replace a DIMM that is currently installed, spread the latches apart on each side of the DIMM
slot, lift the DIMM up at an angle, and pull it out.
XOXOXO
XOXOXO
XOXOXOXOXOXO
XOXOXOXOXO
XOXOXOXOXO
XOXOXOXOXO
XOXOXOXOXO
XOXOXOXOXOXO
XOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXOXO
XOXOXO
XOXOXO
XOXOXO
7. Remove the new DIMM from the antistatic package. Locate the alignment notch on the bottom
edge of the DIMM.
8. Holding the DIMM by the edges, align the notch on the DIMM with the bar in the DIMM slot at an
angle and firmly press the DIMM into the slot until it is fully seated. When installed correctly, the
metal contacts are not visible.
XOXOXO
XOXOXO
XOXOXOXOXOXO
XO
X
OXO
XO
XO
XO
XO
XO
XO
XO
XO
XO
XO
XO
XO
XO
XO
XO
X
O
XO
XOXOXOXOXOXO
XOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXOXO
XOXOXO
XOXOXO
XOXOXO
ENWW Replace supplies 23