To Next Page

To Previous Page

Hardware Reference Guide www.hp.com 2-5

Hardware Upgrades

Removing the Computer Access Panel and

Front Bezel

To remove the computer access panel:

1. If you have locked the Smart Cover Lock, use Computer Setup to

unlock the lock.

2. Turn off the computer properly through the operating system,

then turn off any external devices.

3. Disconnect the power cord from the power outlet and the

computer, and disconnect any external devices.

CAUTION: Before removing the computer access panel, ensure that the

computer is turned off and that the power cord is disconnected from

the electrical outlet.

4. On the top of the computer, locate the cover latch. Pull up and

hold the latch 1 to release the computer access panel.

5. Slide the computer access panel back 2 about 0.5 inch (1.25 cm),

then lift the access panel up and off the chassis.

Removing the Computer Access Panel

Other manuals for HP Compaq d530 SFF

Questions and Answers:

Need help?

Do you have a question about the HP Compaq d530 SFF and is the answer not in the manual?

General

Form Factor	Small Form Factor (SFF)
Processor	Intel Pentium 4 or Intel Celeron
Chipset	Intel 865G
Maximum Memory	4 GB
Graphics	Integrated Intel Extreme Graphics 2
Audio	Integrated AC'97 Audio
Network	Integrated 10/100 Ethernet
Operating System	Windows XP Professional
Power Supply	200W
Memory	256 MB to 2 GB DDR SDRAM
Storage	40 GB HDD
Optical Drive	CD-ROM, DVD-ROM
Expansion Slots	1 PCI
Front Ports	2 USB 2.0
Rear Ports	4 USB 2.0, serial, parallel, VGA